GTS meeting 7 25 16

• 1 mA semi-stable running for nearly 7 hours: [1]
  • At 300kV, with anode bias at +1500 V, and
  • Better beam focusing and centering in the viewers, rather than on the solenoids.
  • We think is the latter that made the greatest contribution to high current beam
  • Even so, we still see sudden "photocathode-anode arcing" that reduces the QE on the illuminated area, but only slightly
  • 

• The cathode is amazingly robust!
  • 

• By moving a hand-held magnet around the gun chamber, "something changed" and now there is field emission starting at around 230kV.
  • This induced several gun HV trips (on current) while attempting to operate at 300kV.
  • We tried Kr processing at no avail. We are then operating at 225kV.

• The QE scanner is operational!
  • The key to make it work was to bias the gun at -1kV, using the Glassman HVPS, and the anode grounded through the Keithley pico-ammeter that reads in EPICS. YEs, for this we need to lock the GTS enclosure in Run mode.
  • The following scan was taken after doing Kr processing. This is why the QE in the un-damaged area is smaller than 2.5%.
  • 

• The masked cathode was installed:
  • 
  • We got beam, with a ring!
  • QE is very low.
  • This cathode is being heat cleaned and will be activated again. Mamun has a better scheme for masking the alkalies.
  •