GTS meeting 1 14 19

List of beamline hardware modifications

1. Replace YAG screen on Viewer 1 - Done
2. Replace Slit on Viewer 2 with holes assembly - Done
3. Replace two ion collectors with new ones
4. Replace Harp fork (Tony)
5. Remove modified DP can - Done
6. Remove Faraday Cup - Done
7. Remove bellow upstream of dump - Done
8. Remove LDR Harp arm and replace with ion-pump
9. Install TE011 Cavity
10. Install Deflecting Cavity - Done
11. Install new 5th solenoid
12. Move DP can 1 to end of beamline - Done
13. All bellows at least 2.5 inch diameter - Done
14. Both gate valves are 2.5 inch-bore and will remain on beamline - Done

List of hardware support

1. Install Deflecting Cavity power supply, MO and other parts
2. Install TE011 Cavity readout cable and electronics

List of software and controls changes

1. Re-program SCAM to allow for 1 Hz and 50 ns macro-pulses
2. Add 5th solenoid to magnet screen

Modification to HV and Preparation chambers

1. Upgrade anode HV bias feed-through to 5 kV
2. Remove anode and clean melted spot
3. Fix Transverse Manipulator
4. Fix Sb boat
5. Clean Sb pellets off chamber