UITF Meeting - January 3, 2020

Additional FSD nodes, some/all will be maskable

Ragowski coil low current BPM, trip beam when position and current exceeds a value determined by Kevin's Labview program
Halo counters at the dump
Halo counters at upstream apertures
Decarad? Will be installed but perhaps not used as FSD
the dump magnet must be ON
Superconducting IBC magnets must be ON, other protection required by ERR committee?
Raster magnets must be ON
some sort of vacuum guage at dump and near target, can be another ion pump current I guess

I&C stuff, Cable pulls:

We need a frequency generator to drive the laser intensity modulator at 1 MHz
We need a copy of the 1 MHz signal delivered to the lockin amplifier rack
Aperture/stepper motor control (three of these, two near HDIce and one at Chopper)
Two viewers behind HDIce
New ADC card to read the SF6 pressure, per Scott Higgins’ request (the old XY566 ADC will be upgraded to a standard VMIc0979 board)
Remote control of the pockel cell voltages, DAC wired to the EMCO HV bricks (we won’t use the fancy RTP driver that Caryn Palatchi has you building, not at UITF)
Fibers (4?) from helicity board to the HDIce target
Ethernet cable from halo counters to….?

RF group:

Buncher 748.5 MHz, and then 1497 MHz
Heaters added to buncher, cabled and fed to 120 VAC box, Hansknecht’s controller
Get 1497 MHz buncher made, fine tuned to be resonant
Buy 1497 MHz 400 W amp
Yao cavity bunch length electronics, software

Phil:

Install 6” blank gasket with 5 mm hole for conductance limitation, in case we vent something, gives us time to close valves to protect the booster
Install manual valve on the elevated beamline, to make it easier to bake this line

Software related:

Computer control:

RadCon:

Navigation menu