HarmonicKicker-2021-06-18

We should talk about the kicker test from a broad perspective to get a realistic sense of the difficulties and options.

What we need to measure

• Measure kick angle of HK as a function of the kicker bucket number
• Measure emittance degradation as a function of the kicker bucket number

What we don't need to measure; correct me if I'm wrong

• impact of ludicrous bunch charges, unless they are needed for diagnostics
• bunch train with multiple "different" buckets filled at the same time

Beam setup and diagnostic options

• Filling all kicker buckets at the same time is possible, but having to geometrically separate the beams poses unnecessary difficulties in terms of beam line optics and temporally sensitive diagnostics.
  • Assumption: bunch frequency = f_RF / 121 = f_Kicker / 7 ~ 12 MHz.
  • All bunches then arrive at the same kicker phase.
  • The kicker phase knob selects the kick voltage.
• Depending on how much space the kicker itself needs, it may need a new beam line of its own or not.
• Measure kick angle with one or two BPMs downstream of the kicker. I feel like we will need two for a good determination of the tilt unless we take precautions to precisely align the launch into the kicker.
• The available BPMs are most likely of a non-resonant type. John and Tom agree that they should be able to detect 12 MHz, though their LPF characteristic means the signal will be down by > 40 dB.
  • Tom: The signal can be measured directly with a 4-ch scope (preamp if necessary). While the pulses are far too short for any scope bandwidth, they could be dispersed relatively easily.
  • John: There is a circuit that will turn the signal into DC, which may be prone to long-term drift but is simple.
  • Provided LHe + laser with this time structure are available, this should be tested ASAP.
• Baseline calibration of BPM readout can be done with CW or tune beam with kicker turned off

• Direct emittance measurement by way of quadrupole scan + transverse profile detector (e.g., harp).
  • Regardless of the kick, the beam always needs to be centered in the lens.
  • Unless I'm missing something, this needs three steering magnets downstream of the kicker to make a chicane that sets up a parallel launch into the lens + harp system (the kicker itself being the fourth steerer).