200kV High Voltage Power Supply & Controls

The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

This page contains information about the high voltage power supply controls used at CEBAF and UITF.

Power Supplies and Controller: +/- 30 kV HVPS [1] AE-30P1-LG (+30kV) and AE-30N1-LG (-30kV) File:Matsusada AE series spec sheet.pdf; Media:Matsusada PS output voltage accuracy.pdf; Media:Matsusada PS quote JeffersonLabAE09062017-1.pdf; Matsusda HV power supplies operations manual Media:Matsusada AE 30kV PS series manual.pdf; Media:CO series communication controller.pdf; Media:CO series REV 0.4.pdf; Media:cable quote.pdf; Media:Matsusada_comm_troubleshooting.txt

Terminals 1-2, 3-4 and 7-8 on the rear of the Matsusada power supplies should be jumpered for correct operation of our application. 1-2 is to allow remote HV enabling (or rather a switch-based disabling, which we don't use). 7-8 allows for remote operation of the supplies.

DIP switches on the rear of the CO-HV controllers need to be set correctly. Switches 1-5 define the unit address. We use address 1 for the positive supply of each Wien, address 2 for the negative supply. Switch 8 defines the 'upper connection' of the optical link, essentially the system master. Set switch 8 on the unit that is addressed 1.

Here is the pinout of the control cable that connects the CO-HV controller to the power supply:

HV Switcher chassis & controls: Media:wien_systems_block_diagram_uitf.pdf; Media:HV switch chassis schematic.pdf; Media:HV switch I0177M1.pdf; Media:HV switch I0178F1.pdf; Media:HV switch I0179F1.pdf; Media:HV switch I0180F1.pdf; Media:g71c.pdf

200kV High Voltage Power Supply & Controls

Navigation menu

Search