Difference between revisions of "2020 Steel Shield Experiments at GTS"

From Ciswikidb
Jump to navigation Jump to search
Line 42: Line 42:
** [[media:Spectral_Radiance_vs_Wavelength_GENERAL.png]] - General plot over all wavelengths
** [[media:Spectral_Radiance_vs_Wavelength_GENERAL.png]] - General plot over all wavelengths
** [[media:Spectral_Radiance_vs_Wavelength_ROI.png]] - ROI for hydrogen spectral lines
** [[media:Spectral_Radiance_vs_Wavelength_ROI.png]] - ROI for hydrogen spectral lines
** [[
** [[media:Spectral_Radiance_vs_Wavelength_ROI_Zoomed.png]] - Zoomed into ROI plot (set y-axis range to see where each temperature's spectrum rises)
[[Ghost Beam Studies | Return to Ghost Beam Studies]]
[[Ghost Beam Studies | Return to Ghost Beam Studies]]

Revision as of 16:45, 19 November 2020

Info on proposed steel shield experiments using the T-Gun at GTS

Previous Parameters

  1. Gun Voltage: 100 kV
  2. Gun Solenoid Current: 150 A. Experiments varied the current between 30 A and 150 A
  3. Anode Voltage: 1 kV (961 V). Experiments varied the anode bias voltage between 388 V and 961 V
  4. Beam Current: 100-500 uA
  5. Gun Vacuum Levels: Usually > 1e-9 A ion pump current at the gun

Proposed Parameters

  1. Gun Voltage: 90 kV (should be fine for experiment purposes)
  2. Gun Solenoid Current: 150 A
  3. Anode Voltage: 1 kV
  4. Beam Current: 500 uA or higher (to ensure sufficient measured intensity from recombining ions)
  5. Gun Vacuum Levels: Higher pressure -> higher ion production rate -> higher number of recombining ions -> higher light intensity and higher probability of measuring recombination light above background

Experimental Procedure

  1. Install Newport silicon photo-diode with power meter on angled view port (photo-diode info: [1] ) Can use a cyan filter to block the red-orange light from cathode (would need to look up the transmittance of the filter to ensure the short-wavelength spectral lines can pass through it)
    • Note that ideally, a "continuous" light measurement would need to be taken to see the rise and fall of the recombination light when the e-beam is turned on and off. Ideally, the light measurement would be compared with other parameters in MyaPlot.
  2. Cover the photo-diode set up with tarp or equivalent opaque material to block out excess sources of light
  3. Take baseline light measurement with e-beam ON (and cathode ON)
  4. Set anode to +1 kV bias. Take light measurement.
  5. Set GS to 150 A. Take light measurement
  6. Set gun HV to 90 kV. Take light measurement
  7. Run e-beam with proposed parameters (above). Take light measurement. Note that this would be the first step that we'd expect to see measurable light above background due to recombination. The measured light should rise and then plateau while the e-beam is on, corresponding to the trap "filling" and reaching equilibrium.
  8. Turn e-beam off. Take light measurement. The measured light should (slowly) fall back to background.
  9. Turn off HV. Take light measurement.
  10. In increments of 10A, bring GS back to 0A. Take light measurement, provided light is seen in the above steps
  11. Return anode bias to 0V. Take final light measurement (should be equal to baseline measurement)

Predicted Results

Relevant Calculations/Tech Notes/Useful Links

Return to Ghost Beam Studies