October 24, 2019 - Weekly AIPINJ Meeting
Revision as of 09:02, 24 October 2019 by Grames
15 deg dipole
- Want (2) work for 200 keV
- Won't run hot
- May be used w/ or w/o steel
- Want (3) sets per Jay's design
- Are tolerances on dwg sufficient ?
- Re-make steel that was machine at UITF (just top/bottom plate, or all?)
- Low -P
(8) Low-P 38mm, $11k ea. (2) Low-P 46mm, $12k ea. (4) Low-P coil, $4k ea. (10) Meas, $7k ea. (1) First article + tooling, $9k
- High -P
(x) High-P, 92mm, $15k ea. ???? (1) First article + tooling, ????