Difference between revisions of "October 27, 2020 - Magnetic field mapping and characterization meeting"
Jump to navigation
Jump to search
(Created page with "*Media:Magnetic field mapping meeting Oct 27 2020.pptx '''Hardware:''' * Use new SCE 20A/75V PS for measurements. This is the same type of PS that will be used for o...") |
|||
Line 7: | Line 7: | ||
* Software will provide EPICS controls and hysteresis ramp loops | * Software will provide EPICS controls and hysteresis ramp loops | ||
* Label and wire coil leads to ensure positive current produces positive B field per convention | * Label and wire coil leads to ensure positive current produces positive B field per convention | ||
− | * | + | * Hysteresis limits: +/- 19.9A |
'''Field mapping:''' | '''Field mapping:''' | ||
Line 19: | Line 19: | ||
'''CED field map''' | '''CED field map''' | ||
− | * | + | * Measure B vs. I at center of magnet using the EPICS hysteresis cycle at the beginning then top down through currents. |
'''Other measurements:''' | '''Other measurements:''' | ||
* V vs I resistance and inductance. | * V vs I resistance and inductance. |
Latest revision as of 15:20, 27 October 2020
Hardware:
* Use new SCE 20A/75V PS for measurements. This is the same type of PS that will be used for oparations * DC power will install new SCE PS in magnet test ~10/29/20 * Software will provide EPICS controls and hysteresis ramp loops * Label and wire coil leads to ensure positive current produces positive B field per convention * Hysteresis limits: +/- 19.9A
Field mapping:
* Hall probe step size 2 mm * On axis values z=[-25,25] cm * Background: measure z=[-30,30] cm. First run the probe in this range w/o the magnet. Then place the magnet for measurements and do a full map at 0 A after hysteresis at 0A . Finally subtract from each value. * Off axis values: limited by 15 mm diameter nickel endplates hole and 6 mm square hall probe. Measure z=[-25,25] cm once at 18A and as far as these limitations allow in +X,-X,+Y,-Y and record X,Y positions for comparing with models. * Measure at +/-19.9A, +/- 15A, +/- 10A, +/-5A and 0A.
CED field map
* Measure B vs. I at center of magnet using the EPICS hysteresis cycle at the beginning then top down through currents.
Other measurements:
* V vs I resistance and inductance.