Phase 1 - HCO & Commissioning

Jobs Leading to HCO & Commissioning

15 deg dipole (MDR)

• Install on beam line after bake out, then align, do we use shims?
• Current sensor for HV interlock installed and tested, ready for DC power, to set limits, fault test
• Current sensor for FSD installed and tested, calibrated for FSD card, ready for DC power, to set limits, fault test
• Update drawings and documentation

Laser jobs

• Complete outrigger box, install, test with laser room shutter, update LSOP
• Flush chiller, decide on PM schedule, fill
• Re-install Hall B amp in permanent location
• Complete macropulse chassis upgrade (replace 18 VDC + booster with 24 VDC, add protection diode to shutters), test all beam modes

Wien HVPS

• (done) Add placards to ISB racks
• Install HV Switcher chassis at ISB, complete cabling between rack components
• Drop/pull HV cables from HV switcher outputs to Wiens

Ion Pump Power Supplies

• (done) Finalize IP names for songsheet
• Complete mapping between all IP and power supplies (gun to choppers)
• Complete UHV power supply upgrade, remove temp PS, spare PS on shelf (identify cabinet area for spares)
• Work with software to reprogram UHV PS EPICS names, can we have unique identifier from old names?
• Re-install (2) HV patch boxes, update box labels, pull HV drop cables to patch boxes, updated labels

Valves

• Controls for (3) gate valves

Air, GN2, LCW

• Move GN2 near gun lower, hook for air lines, caps for poly hose
• Add 2nd GN2 near girder, hook for air lines, caps for poly hose
• Fabricate, install air manifold for viewers and valves
• (done) Re-install LCW manifold

Electrician jobs

• Relocate floor outlets
• Bond girders (Shaun has holes drilled on girders already for this)
• Install cable tray