View source for NPS ERR Prep 2/1/19

GENERAL DOCUMENTATION

* Collect information on subsystems 


MAGNET

* Plan for mapping and running
::* Hi-pot testing, hydro testing, checklists, 5 G boundaries and field measurements, controls pre-checked out, measured vs calculated results, safety checks and controls, back out procedures

* Safety and operation documents - can check with J. Beaufait, E. Folts, et al.


FRAME

* Timeline for construction and assembly, and resources

* Define alignment and survey requirements - how well do we need to know
::* note that for NPS at 3-4m from target knowing position to mm is ~0.1mrad


CRYSTALS

* Expected number of crystals and when anticipate to have them

* Finalize layout with final number of SICCAS and CRYTUR crystals


HV DIVIDERS AND PMTs

* Check dividers for lower voltage range (600-700 V) - Fernando, Alex S. and student might be able to help too

* Check into bypassing amplifier - Fernando has a way to do that and it affects the easy to modify part of the board


HALL C - MECHANICAL

* Strengthen bottom support, pivot

* Installation plan


HALL C - POWER AND CABLING

* Timeline for decisions and planning


HALL C - DAQ AND ELECTRONICS

* Trigger Bandwidth - highest rate expected from NPS (collaboration input)

* Dynamic range expected for signals (collaboration input)


HALL C - TRIGGER AND ELECTRONICS

* How software chain handles data rates - online monitoring

* Confirm ~4kHz rate on HMS side