Difference between revisions of "HPS 2016 Trigger Commissioning"

From hps run
Jump to navigation Jump to search
Line 35: Line 35:
  
 
Ideally the pedestal runs above ~50 nA should be done first so that they can be used<br>
 
Ideally the pedestal runs above ~50 nA should be done first so that they can be used<br>
to update the pedestals used for the 20 kHz Pulser runs (for 25 nA, the current pedestals<br>
+
to update the pedestals used for the 20 kHz Pulser runs.  For 25 nA, no new pedestals <br>
are fine). ''This requires an ECal expert available, and to then update the trigger files''
+
are needed. ''Taking pedestal runs requires an ECal expert available, and to then update''<br>
''for the subsequent Pulser runs.''   
+
''the trigger files for the subsequent Pulser runs.''   
  
 
'''If this is not the case, all the Pulser runs can be done first with the preconfigured pedestals.'''
 
'''If this is not the case, all the Pulser runs can be done first with the preconfigured pedestals.'''

Revision as of 19:48, 13 February 2016

Phase 0: Diagnostics

  1. One Run with Singles & Pairs Triggers
    • trigger file: HPS/Run2016/v0.trg
    • 30 minutes at any fixed current of 25 nA or greater
    • This trigger configuration should give non-zero rates for all triggers:
      • singles-0, singles-1, pairs-0, pairs-1

Phase 1: Preliminary Tuning

  1. Three Singles+Pairs Trigger Runs
    • trigger file: HPS/Run2016/v0.trg
      • Pair-1 is Kyle's tight A' trigger
    • This trigger configuration should give non-zero rates for all triggers:
      • singles-0, singles-1, pairs-0, pairs-1
      • and 1 kHz pulser
    • 10 minutes at each beam current:
      • 25 nA (or lower)
      • 100 nA
      • 200 nA (If dead time is greater than 25%, lower the beam current)
    • Take a snapshot of the trigger scalers at each current

  1. ECal Pedestal Runs
    • About 10 minutes at each beam current:
      • 25 nA (or lower)
      • 100 nA
      • 200 nA
  2. Three 20 kHz Pulser Runs
    • trigger file: HPS/Run2016/pulser20kHz.trg
    • At least 100 Million events (~1 hour) at each beam current:
      • 25 nA (or lower)
      • 100 nA
      • 200 nA

Ideally the pedestal runs above ~50 nA should be done first so that they can be used
to update the pedestals used for the 20 kHz Pulser runs. For 25 nA, no new pedestals
are needed. Taking pedestal runs requires an ECal expert available, and to then update
the trigger files for the subsequent Pulser runs.

If this is not the case, all the Pulser runs can be done first with the preconfigured pedestals.

Phase 2: Final Tuning

coming soon