Difference between revisions of "The HPS Run Wiki"

Revision as of 17:09, 8 December 2014

[edit]

Shift Documentation
Short Term Schedule
Long Term Schedule
Accelerator
Monitoring

HPS Phone/Pager Numbers

Checklists

Procedures

Commissioning Plans:
- Beamline
- Trigger
- ECal
- SVT
SVT TOSP (1,2,3)

Manuals

JLab Logbooks

RC: John Jaros

(757) 575-7540
9 575 7540 from Counting Room

PDL: Harut Avagyan

Every Shift:

Follow run plan as outlined by RC
Keep shift summery up-to-date in HBLOG
Document any beam condition change and send scaler GUIs to HBLOG
Send "scaler_hps" GUI to logbook at least twice per shift or any time run conditions change
Continuously check quality of data

Every Run:

a
b
c
d

MCC Daily Meetings

Run Plan: Dec. 7 - Dec. 9

Beamline commissioning studies using the Hall B dump, followed by studies of the ECal and Trigger. The goal is to get usable CW beam to the Hall-B dump, set up the chicane, and begin to study beam backgrounds and trigger rates.

Establish CW 1 pass beam to the Hall-B dump, including checkout of all new beamline components, BPMs, quads, correctors, and harps.
Work with MCC crew to establish small size stable beam at the alcove harp - beam parameters sig X ~ 150 micron, sig Y ~50 micron, with low noise in the downstream halo counters and ecal.
Perform harp scans using 2H02 harp. Optimize halo counter voltages as needed.
Once good beam is established, commission the chicane magnet, including a study of noise rates (halo counters + ecal) vs B field. (We may need to run slightly lower than nominal B for our given beam energy to afford adequate clearance to the 3 inch beam pipe connected to the new target assembly.The beam pipe must accommodate both straight through and Frascati bent beams.)
Commission the HPS target, including measuring noise rates in the Ecal and halo counters vs beam current.
If time allows, begin commissioning the Ecal and trigger with beam on target and data taking.
- See Full PDF, Click Here
- With any issue, contact Beamline Expert or RC.

Beam
Energy	~2.0 GeV
Current	< 200.0 nA CW
Position
X	Y
~0 mm	~0 mm
Profile
X	Y
< 0.1 mm	< 0.1 mm

Target
#1	0 mm

Magnets
PS Current	0 A
Chicane Dipole #1	0 A
Chicane Dipole #2	0 A

DAQ
Configuration	___________________
Configuration file
Prescales
Thresholds
Events Per Run
Dead Time

Run Coordinator
X - Nov 19	Stepan Stepanyan
Nov 19 - Dec 3	Nathan Baltzell
Dec 3 - 9	John Jaros
Dec 9 - 22	Takashi Maruyama

Physics Division Liaison
X -	Harut Avakian
DATE	NAME

Webcams only accessible inside Hall gateway.

@@ Line 38: / Line 38: @@
 ** [https://clonwiki.jlab.org/wiki/index.php/DAQ/Online_Quick_Reference CLAS Wiki] ([[HPS DAQ Quick Reference|copy]])
 * [[Media:hps_beamline_manual.pdf|Beamline]]
+**[[Media:chicane_ON-OFF.pdf|Turning ON/OFF chicane]]
 * [[Media:hps_slow_controls_manual.pdf|Slow Controls]]
@@ Line 64: / Line 65: @@
 |}
 = '''Short Term Schedule''' =