Difference between revisions of "2018 Data - Analysis Page"

From Xem2
Jump to navigationJump to search
Line 33: Line 33:
 
** Electronic dead time
 
** Electronic dead time
 
** FADC dead time (100 ns)???
 
** FADC dead time (100 ns)???
 +
* EMC only
 +
** Isoscalar corrections

Revision as of 09:57, 1 February 2021

2018 Data: Analysis Summary

Target Information

  • Target configuration report
    • Note: cryotargets need to subtract window thickness and apply a correction of 0.996 due to length contraction at low temperature
  • Solid target notes
    • Note: I think there was a transcription error for the carbon target. The report says 0.5244 g/cm2. I get 0.5224 g/cm2 from the notes above.
  • Beam and target offsets:
    • Analysis of SHMS/HMS C data (log entry needed)
    • Offsets to put in MC (from email from Abishek)
      • x-spec offset = +0.127 cm
      • y-spec offset = -0.057 cm
      • x-beam offset = (0.073 - x-bpm) cm
      • z-target offset = 0.212 cm (carbon target)
  • How I get Boron from B4C: [1]

BCM calibration

  • Summary from Deb
  • Correction for runs 2557-2563 (multiply charge by 1.0115) XEM2 elog 60

Efficiencies and corrections

  • Target Boiling
    • LH2 target:
    • LD2 target:
  • SHMS
    • NGC efficiency lookup table: F2 elog 317
    • Calorimeter efficiency: F2 elog 287 (can't find log entry with polynomial form)
    • Trigger efficiency
    • Electronic dead time
    • FADC dead time (100 ns)???
  • HMS
    • Cerenkov efficiency
    • Calorimeter efficiency
    • Trigger efficiency
    • Electronic dead time
    • FADC dead time (100 ns)???
  • EMC only
    • Isoscalar corrections