Difference between revisions of "Spring SAD 2019"

Revision as of 11:33, 11 April 2019

MONDAY, APRIL 15: Measure PQB vs optical pulse shape - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19069; Measure chopper focal length vs. radial position - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18996

SAD JOBS: Add HVPS burst disk, charge 60psi, set trip-points - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18915; PREX source setup (hel board, laser table, photocathode ) - Caryn is writing high level punchlist....; Gun2 photocathode exchange - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071; Heat & activate Gun2 photocathode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18967; Install new anode bias supply controls ISB - Sue will write one for software...; Reconfigure Hall D laser with PM pre-amp in ISB for testing - http://devweb.acc.jlab.org/CSUEApps/atlis/task/19070; Bias Gun2 anode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18968; Install helicity quad for testing - Joe is working on this one...; Remove Mott dump dipole - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993

@@ Line 9: / Line 9: @@
 :Heat & activate Gun2 photocathode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18967
 :Install new anode bias supply controls ISB - Sue will write one for software...
-:Reconfigure Hall D laser with PM pre-amp in ISB for testing - Shukui is writing this one...
+:Reconfigure Hall D laser with PM pre-amp in ISB for testing - http://devweb.acc.jlab.org/CSUEApps/atlis/task/19070
 :Bias Gun2 anode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18968
 :Install helicity quad for testing - Joe is working on this one...
 :Remove Mott dump dipole - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993