Difference between revisions of "Spring SAD 2019"
Jump to navigation
Jump to search
| Line 25: | Line 25: | ||
;<span style="color:#ff0000">Gun2 photocathode exchange</span> | ;<span style="color:#ff0000">Gun2 photocathode exchange</span> | ||
::*http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071 | ::*http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071 | ||
| + | ::*SSL DBR 75105-2 wafer mounted on puck 36 - https://logbooks.jlab.org/entry/3677005 | ||
;<span style="color:#ff0000">Heat & activate Gun2 photocathode</span> | ;<span style="color:#ff0000">Heat & activate Gun2 photocathode</span> | ||
Revision as of 08:30, 16 April 2019
- Remove Mott dump dipole
-
- http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993
- MMF magnet assessment (4/11/19) media:5MeVMOTT_4_9_2019.xlsx
- Test Vertical Wien filter for PREX spin flip
- Measure PQB vs optical pulse shape
- Measure chopper focal length vs. radial position
- Measure Hall B laser circular polarization
- Add HVPS burst disk, charge 60psi, set trip-points
- PREX source setup (hel board, laser table, photocathode )
- Gun2 photocathode exchange
-
- http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071
- SSL DBR 75105-2 wafer mounted on puck 36 - https://logbooks.jlab.org/entry/3677005
- Heat & activate Gun2 photocathode
- Install new anode bias supply controls ISB
-
- Sue will write one for software...
- Reconfigure Hall D laser with PM pre-amp in ISB for testing
- Bias Gun2 anode
- Install helicity quad for testing
-
- Joe is working on this one...