Difference between revisions of "GTS meeting 2 16 16"
Jump to navigation
Jump to search
| Line 2: | Line 2: | ||
* [[Media:GTS Beamline component list.xlsx]] | * [[Media:GTS Beamline component list.xlsx]] | ||
| + | * Design Update – Puck and Gun Magnet: [[media:Design_Update-Puck-GunMagnet.pdf]] [[media:Design_Update-Puck-GunMagnet.pptx]] | ||
| − | * | + | * Update: Beamline has been aligned, but we are checking with C. Curtis about the dump vertical position: [[File:Dump bellows side view 01.jpg]] |
| + | |||
| + | * Update: We are working on the cathode prep chamber, BUT the gate valve separating it form the gun seems to leak through. | ||
| + | |||
| + | * Bubba made barrel polishing work!!! | ||
| + | ** Upon receiving electrode form machine shop, we had to use file to remove deep markins | ||
| + | ** Then he used 320 grit sand paper | ||
| + | ** and finally, used 70% barrel full with corncob, and let the ball bounce for ~20 hours. | ||
| + | ** By polishing a small section with diamond paste (1 micron) he concluded that the finish is equivalent to that he obtains with DPP. | ||
| + | ** Next, polish shed! Bubba has a recipe from Mass Finishing for using first plastic cones in the tumbler, instead of the 320 grit sand paper...curious minds awiat | ||
| + | |||
| + | * [[File:UITF ball corncob polished bottom view.jpg]] | ||
| + | * [[File:UITF ball corncob polished side view.jpg]] | ||
| + | * [[File:UITF ball corncob polished sideview 2.jpg]] | ||
| + | * [[File:UITF ball corncob closeup view.jpg]] | ||
Revision as of 09:32, 16 February 2016
- Design Update – Puck and Gun Magnet: media:Design_Update-Puck-GunMagnet.pdf media:Design_Update-Puck-GunMagnet.pptx
- Update: Beamline has been aligned, but we are checking with C. Curtis about the dump vertical position:
- Update: We are working on the cathode prep chamber, BUT the gate valve separating it form the gun seems to leak through.
- Bubba made barrel polishing work!!!
- Upon receiving electrode form machine shop, we had to use file to remove deep markins
- Then he used 320 grit sand paper
- and finally, used 70% barrel full with corncob, and let the ball bounce for ~20 hours.
- By polishing a small section with diamond paste (1 micron) he concluded that the finish is equivalent to that he obtains with DPP.
- Next, polish shed! Bubba has a recipe from Mass Finishing for using first plastic cones in the tumbler, instead of the 320 grit sand paper...curious minds awiat
