Difference between revisions of "Run1 - January 2015"
Jump to navigation
Jump to search
| Line 5: | Line 5: | ||
= Shift Worker Duties = | = Shift Worker Duties = | ||
| − | + | ; Beam Driver | |
| − | + | Beam setup: gun + laser + spin + beam to Mott | |
| − | + | BCM & target motion FSDs enabled | |
| − | + | Vacuum levels reasonable | |
| − | + | Magnet and RF setup saved | |
| − | + | PITA adjusted for IHWP IN/OUT | |
| − | + | ; DAQ Driver | |
| − | + | Start/Stop DAQ entering correct run information | |
| − | + | Monitor event rates and maintain dead time <5% | |
| − | + | Coordinate run start/stop with Beam and Analysis Drivers | |
| − | + | ; Analysis Driver | |
| − | + | Runs decoded, analyzed and promptly inspected | |
| − | + | Run # and information logged onto run sheets | |
| − | + | Elastic events counted for IHWP=IN/OUT | |
Revision as of 13:44, 12 January 2015
This page will be used for the Run 1 experiment and analysis
Shift Schedule
Shift Worker Duties
- Beam Driver
Beam setup: gun + laser + spin + beam to Mott BCM & target motion FSDs enabled Vacuum levels reasonable Magnet and RF setup saved PITA adjusted for IHWP IN/OUT
- DAQ Driver
Start/Stop DAQ entering correct run information Monitor event rates and maintain dead time <5% Coordinate run start/stop with Beam and Analysis Drivers
- Analysis Driver
Runs decoded, analyzed and promptly inspected Run # and information logged onto run sheets Elastic events counted for IHWP=IN/OUT
Version 4 Notes