Difference between revisions of "Run1 - January 2015"
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
Elastic events counted for IHWP=IN/OUT | Elastic events counted for IHWP=IN/OUT | ||
| − | + | = Prep Work (through Tuesday Jan 13) | |
| + | #Make a photocathode – SL5247-1 made | ||
| + | #Test IHA2D00 – wires & stroke good, but data file odd vs. others | ||
| + | #Hi-Pot IP – FE’r potted, but high again, vac readback not good | ||
| + | #CHL 2K cooldown – maybe early, Monday Jan 12th | ||
| + | #Install laser – Tue or Wed | ||
| + | #Test laser RF trigger – after laser installed (1V, 10ns @ RF) | ||
| + | #Verify beam line layout –documented below | ||
| + | #Build elegant deck – working | ||
| + | #Build qsUtility config file –documented below | ||
Version 4 Notes | Version 4 Notes | ||
* Word [[media:Mott_Run1_v4.docx]] | * Word [[media:Mott_Run1_v4.docx]] | ||
* PDF [[media:Mott_Run1_v4.pdf]] | * PDF [[media:Mott_Run1_v4.pdf]] | ||
Revision as of 13:45, 12 January 2015
This page will be used for the Run 1 experiment and analysis
Shift Schedule
Shift Worker Duties
- Beam Driver
Beam setup: gun + laser + spin + beam to Mott BCM & target motion FSDs enabled Vacuum levels reasonable Magnet and RF setup saved PITA adjusted for IHWP IN/OUT
- DAQ Driver
Start/Stop DAQ entering correct run information Monitor event rates and maintain dead time <5% Coordinate run start/stop with Beam and Analysis Drivers
- Analysis Driver
Runs decoded, analyzed and promptly inspected Run # and information logged onto run sheets Elastic events counted for IHWP=IN/OUT
= Prep Work (through Tuesday Jan 13)
- Make a photocathode – SL5247-1 made
- Test IHA2D00 – wires & stroke good, but data file odd vs. others
- Hi-Pot IP – FE’r potted, but high again, vac readback not good
- CHL 2K cooldown – maybe early, Monday Jan 12th
- Install laser – Tue or Wed
- Test laser RF trigger – after laser installed (1V, 10ns @ RF)
- Verify beam line layout –documented below
- Build elegant deck – working
- Build qsUtility config file –documented below
Version 4 Notes