Difference between revisions of "UITF Operation How To's"
Jump to navigation
Jump to search
(Created page with "===Using UITF Alarm Handler=== * [https://opswiki.acc.jlab.org/wiki/Alarms Alarms document] maintained by Ops * [https://opswiki.acc.jlab.org/wiki/TemplateAlarm Template alar...") |
|||
| Line 4: | Line 4: | ||
* [https://opswiki.acc.jlab.org/wiki/TemplateAlarm Template alarm] describes configuration options | * [https://opswiki.acc.jlab.org/wiki/TemplateAlarm Template alarm] describes configuration options | ||
* [https://accwiki.acc.jlab.org/do/view/SWDocs/OnCallHelpRestartAlarmHandler This software] on-call wiki describes the known issues with the alarm handler system. And some common problems and their solutions. | * [https://accwiki.acc.jlab.org/do/view/SWDocs/OnCallHelpRestartAlarmHandler This software] on-call wiki describes the known issues with the alarm handler system. And some common problems and their solutions. | ||
| + | |||
| + | ===SRF Trip (SEL => GDR)=== | ||
| + | |||
| + | * Procedure for recovering from a “trip”, where trip means the rf switches from GDR mode to SEL mode. We can’t drive beam in SEL mode | ||
| + | |||
| + | #Hit master reset on expert page | ||
| + | #Close the switch | ||
| + | #Wait for the discriminator value to become small, then switch to GDR mode using the “seltogdr” button | ||
| + | #Don’t resend beam until you see Gmeas = to GSet, this takes about a minute | ||
| + | #Clear the FSD assuming the BLMs are not masked, look for beam on viewer | ||
Latest revision as of 07:58, 15 August 2020
Using UITF Alarm Handler
- Alarms document maintained by Ops
- Template alarm describes configuration options
- This software on-call wiki describes the known issues with the alarm handler system. And some common problems and their solutions.
SRF Trip (SEL => GDR)
- Procedure for recovering from a “trip”, where trip means the rf switches from GDR mode to SEL mode. We can’t drive beam in SEL mode
- Hit master reset on expert page
- Close the switch
- Wait for the discriminator value to become small, then switch to GDR mode using the “seltogdr” button
- Don’t resend beam until you see Gmeas = to GSet, this takes about a minute
- Clear the FSD assuming the BLMs are not masked, look for beam on viewer