Difference between revisions of "Run1 - January 2015"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
= Shift Schedule = | = Shift Schedule = | ||
[[File:140112_shifts.png|thumb|center|300px]] | [[File:140112_shifts.png|thumb|center|300px]] | ||
| + | |||
| + | = Shift Worker Duties = | ||
| + | • Beam Driver | ||
| + | o Beam setup: gun + laser + spin + beam to Mott | ||
| + | o BCM & target motion FSDs enabled | ||
| + | o Vacuum levels reasonable | ||
| + | o Magnet and RF setup saved | ||
| + | o PITA adjusted for IHWP IN/OUT | ||
| + | • DAQ Driver | ||
| + | o Start/Stop DAQ entering correct run information | ||
| + | o Monitor event rates and maintain dead time <5% | ||
| + | o Coordinate run start/stop with Beam and Analysis Drivers | ||
| + | • Analysis Driver | ||
| + | o Runs decoded, analyzed and promptly inspected | ||
| + | o Run # and information logged onto run sheets | ||
| + | o Elastic events counted for IHWP=IN/OUT | ||
| + | |||
| + | |||
Version 4 Notes | Version 4 Notes | ||
* Word [[media:Mott_Run1_v4.docx]] | * Word [[media:Mott_Run1_v4.docx]] | ||
* PDF [[media:Mott_Run1_v4.pdf]] | * PDF [[media:Mott_Run1_v4.pdf]] | ||
Revision as of 13:43, 12 January 2015
This page will be used for the Run 1 experiment and analysis
Shift Schedule
Shift Worker Duties
• Beam Driver o Beam setup: gun + laser + spin + beam to Mott o BCM & target motion FSDs enabled o Vacuum levels reasonable o Magnet and RF setup saved o PITA adjusted for IHWP IN/OUT • DAQ Driver o Start/Stop DAQ entering correct run information o Monitor event rates and maintain dead time <5% o Coordinate run start/stop with Beam and Analysis Drivers • Analysis Driver o Runs decoded, analyzed and promptly inspected o Run # and information logged onto run sheets o Elastic events counted for IHWP=IN/OUT
Version 4 Notes