Difference between revisions of "September 30, 2015 - Fall Startup and Injector Tests"

Revision as of 11:27, 30 September 2015

By Nov. 9th the following things MUST be accomplished.

1. CW beam to the inline dump 85uA from A laser, 1uA from the D laser

2. Wien setup for alignment of polarization to Hall-A on 5-pass

3. Quads, solenoids centered (where appropriate) and the determined BPMs SOF loaded, see item 6

4. Beam matched in the inj. chicane, ready for transport into the NL.

5. All lasers should produce beam with the same TWISS/emittance values as measured in the inj. chicane

6. RF calibration tool fully developed (anticipate Nov. 2-7 DAYS)

7. quad centering tool fully developed (anticipate Nov. 2-7 DAYS)

@@ Line 1: / Line 1: @@
+By Nov. 9th the following things MUST be accomplished.
+. CW beam to the inline dump 85uA from A laser, 1uA from the D laser
+. Wien setup for alignment of polarization to Hall-A on 5-pass
+. Quads, solenoids centered (where appropriate) and the determined BPMs SOF loaded, see item 6
+. Beam matched in the inj. chicane, ready for transport into the NL.
+. All lasers should produce beam with the same TWISS/emittance values as measured in the inj. chicane
+. RF calibration tool fully developed (anticipate Nov. 2-7 DAYS)
+. quad centering tool fully developed (anticipate Nov. 2-7 DAYS)
 Injector Tests and Calendar [[media:150929_InjectorTestList.xlsx]] [[media:150929_InjectorTestList.pdf]]