Spring SAD 2019

SAD JOBS (Green/span> indicates completed)

1. Measure PQB vs optical pulse shape - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19069
2. Measure chopper focal length vs. radial position - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18996
3. Add HVPS burst disk, charge 60psi, set trip-points - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18915
4. PREX source setup (hel board, laser table, photocathode ) - Caryn is writing high level punchlist....
5. Gun2 photocathode exchange - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071
6. Heat & activate Gun2 photocathode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18967
7. Install new anode bias supply controls ISB - Sue will write one for software...
8. Reconfigure Hall D laser with PM pre-amp in ISB for testing - http://devweb.acc.jlab.org/CSUEApps/atlis/task/19070
9. Bias Gun2 anode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18968
10. Install helicity quad for testing - Joe is working on this one...
11. Remove Mott dump dipole - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993