Spring SAD 2019
Jump to navigation
Jump to search
SAD JOBS (Green/span> indicates completed)
- Test Vertical Wien filter for PREX spin flip
- Measure PQB vs optical pulse shape
- Measure chopper focal length vs. radial position
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18996
- Measure Hall B laser circular polarization
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19093
- Add HVPS burst disk, charge 60psi, set trip-points
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18915
- PREX source setup (hel board, laser table, photocathode )
http://devweb.acc.jlab.org/CSUEApps/atlis/task/19090
- Gun2 photocathode exchange
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071
- Heat & activate Gun2 photocathode
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18967
- Install new anode bias supply controls ISB
Sue will write one for software...
- Reconfigure Hall D laser with PM pre-amp in ISB for testing
http://devweb.acc.jlab.org/CSUEApps/atlis/task/19070
- Bias Gun2 anode
http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18968
- Install helicity quad for testing
Joe is working on this one...
- Remove Mott dump dipole
- http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993
- MMF magnet assessment (4/11/19) media:5MeVMOTT_4_9_2019.xlsx