Difference between revisions of "Spring SAD 2019"
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
#<span style="color:#ff0000">Install helicity quad for testing</span> - Joe is working on this one... | #<span style="color:#ff0000">Install helicity quad for testing</span> - Joe is working on this one... | ||
#<span style="color:#008000">Remove Mott dump dipole</span> - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993 | #<span style="color:#008000">Remove Mott dump dipole</span> - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993 | ||
| + | :4/11/19 - MMF magnet assessment [[media:5MeVMOTT_4_9_2019.xlsx]] | ||
Revision as of 13:00, 11 April 2019
SAD JOBS (Green/span> indicates completed)
- Measure PQB vs optical pulse shape - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19069
- Measure chopper focal length vs. radial position - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18996
- Add HVPS burst disk, charge 60psi, set trip-points - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18915
- PREX source setup (hel board, laser table, photocathode ) - Caryn is writing high level punchlist....
- Gun2 photocathode exchange - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/19071
- Heat & activate Gun2 photocathode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18967
- Install new anode bias supply controls ISB - Sue will write one for software...
- Reconfigure Hall D laser with PM pre-amp in ISB for testing - http://devweb.acc.jlab.org/CSUEApps/atlis/task/19070
- Bias Gun2 anode - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18968
- Install helicity quad for testing - Joe is working on this one...
- Remove Mott dump dipole - http://opsweb.acc.jlab.org/CSUEApps/atlis/task/18993
- 4/11/19 - MMF magnet assessment media:5MeVMOTT_4_9_2019.xlsx