Difference between revisions of "General EEEMCal Meeting Summary 10/4/24"
Jump to navigation
Jump to search
(Created page with "'''NSF PREPROPOSAL PREPARATIONS''' * Submission to CUA SPO: 4 November '''DESY BEAMTEST PREPARATIONS ''' '''IJCLAB-ORSAY ''' * Tested first article - optimized some mechan...") |
|||
| Line 46: | Line 46: | ||
::* Timing to synchronize digitizers | ::* Timing to synchronize digitizers | ||
| − | ''' | + | |
| − | NEXT MEETING: FRIDAY 18 OCTOBER AT 8:00AM ET''' | + | '''NEXT MEETING: FRIDAY 18 OCTOBER AT 8:00AM ET''' |
Revision as of 16:41, 4 October 2024
NSF PREPROPOSAL PREPARATIONS
- Submission to CUA SPO: 4 November
DESY BEAMTEST PREPARATIONS
IJCLAB-ORSAY
- Tested first article - optimized some mechanical alignments
- Sent out final order for PCBs - delivery date is October 21st
- Alignment of SiPMS
- Discrete Readout: Larry finished the board designs. Need to procure cables (bias and signal) and board fabrication for the discrete readout
- Action item: Gerard will check with Fernando how to fund board fabrication and cable procurement
- A few notes on cables: Coax cables for signal - MCX to adapt to BNC. Also still need bias cables - Justin/Tristan need to make these, but the cables and connectors need to be purchased
MIT
- All equipment on route to DESY
- Two channels SiPM: Larry prepared the boards and sent to JLab where Josh has been working on assembly and testing
- assembly was completed, but some work remains on the testing
CRYTUR
- Hamamatsu SiPM 14160-6010 - 10um, 6mmx6mm, 4x4 SiPM
- Assume MIT readout, have BNC cables for connection
ONLINE SOFTWARE
- Work ongoing towards online histograms
- Portable SSD drive (~3T needed) should work to copy all data
DRAFT RUN PLAN
- Planning to use only waveform digitizer, no QDC
- Timing to synchronize digitizers
NEXT MEETING: FRIDAY 18 OCTOBER AT 8:00AM ET