Difference between revisions of "Installation and welding activities"

Latest revision as of 11:38, 31 July 2018

Current Task List - [[1]]

@@ Line 1: / Line 1: @@
 Current Task List - [[https://wiki.jlab.org/lerf/images/6/66/Remaining_tasks.pdf]]
-== Remaining tasks for LCLS-II Cryomodule testing ==
-Kevin Jordan 7/26/2018
-System	Task	Group Responsible	Notes
-Installation / Pipe fitting / Welding PRIOR to testing
-Transferline
-	Confirm/Prep both transferline sections have proper weld prep	Cryo
-	Locate and affix to floor short piece	Installation
-	Locate and affix to floor  "L" piece	Installation
-	Position/align both sections with ruler and level bar	Cryo
-	Cut, prep, & weld field fit joints per weld spec - w/M. Martin advice	Cryo
-	Leak check innner connections prior to SI wrap	Cryo/SRF?
-	Cut/prep & weld clam shells	Cryo
-Warm Helium Piping
-	Prep, mount, and weld sections of warm piping per spec & drawings	Cryo	Much of this is to be done after the cryo-can is located & grouted
-Cryo-Can
-	Remove/install equipment that is too tall for cable tray/waveguide	Gubeli	Ensure that it can be moved into place w/o hight restrictions like relief stack
-	Confirm/Prep the weld joints have proper weld prep	Cryo
-	Locate Cryo-can per surveyed drill locations	Installation
-	Confirm alignment to field fit transferline 	Survey/Gubeli
-	Drill, mount/level can, grout base plate	Installation
-	Cut to fit, weld & leak check inner Helium piping	Cryo
-	Wrap SI insulation	Cryo/SRF
-	Cut to fit & weld outer clam shells	Cryo
-Clean Room Assembly
-	Unpack & assemble	Electricians	This can be done once the cryo-Can has been moved into place
-	Install AC power and lights	Electricians
-=== Work to move, locate, and join 2 cryomodules prior to testing ===
-== Movement ==
-	Bolt on wheels	SRF	Installation crew can assist if required
-	Arrange for crane at LERF to Lower/Raise CMs	Installation
-	Move to/from Test Lab	SRF
-	Wheel in/out LERF	SFR/Installation
-	Locate/position CMs	SFR/Survey	This will likely be done wioth plumb bobs
-Cleanroom beam tube connection
-	Prepare & execute center beam tube connections in cleam room per procedures	SRF/Vac	This is the effort to join two modules together
-	Insulate	SRF
-Cryo-Can & Center Bellows	* these details are TBD *
-	Affix the bellows to cart	Installation (?)	The cryo-can bellows may arrive on the end of the CM - TBD
-	Position cryo-can bellows	SRF	The cart enables ease of installation in the joining region
-	Secure cryo-can bellows	SRF
-	Position center bellows		These connect the vacuum space of the two CMs together
-	Secure center bellows
-Cooldown
-	Follow Mike Drury's proceedures

Difference between revisions of "Installation and welding activities"

Latest revision as of 11:38, 31 July 2018

Navigation menu

Search