Revision as of 11:22, 5 November 2015

The review will take place at 8:30 am November 12, 2015 in L102

Agenda

8:30 Executive Session
9:00 Physics goals of the PRad experiment (15 min) - Haiyan Gao
9:15 Overview of the experimental setup, required beam parameters, alignment, HyCal, run plan (30 minutes) - Ashot Gasparian
9:45 Coexistence with CLAS12 project, including discussion of schedule, manpower needs, service provider needs, and infrastructure requirements (30 min) - Eugene Pasyuk
- PRad Installation Schedule
10:15 Coffee Break
10:30 Target: parameters, safety (20 min) - Chris Keith
- PRad target manual and hazard analysis
- PRad target operation manual
10:50 GEM and DAQ integration (20 min) - Nilanga Liyanage
11:10 DAQ, on-line and off-line software (20 min) - Chao Peng
11:30 Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min) - Bob Miller
12:00 PRad Beam Commissioning and Procedures (20 min) - Arne Freyberger
12:20 Run documentation COO, ESAD, RSAD, etc. (30 min) - Dipangkar/Mahbub
12:50 Lunch
13:30 Executive Session
15:30 Closeout

@@ Line 58: / Line 58: @@
 * Vacuum vessel
-** [   Engineering calculations by vendor]
+** [https://wiki.jlab.org/pcrewiki/images/f/f2/J02351_Calcs.pdf   Engineering calculations by vendor]
-** [   Additional engineering calculations by vendor]
+** [https://wiki.jlab.org/pcrewiki/images/a/a6/JSA15-PO128_Addtional_Calculations.pdf   Additional engineering calculations by vendor]
-** [   Review of calculations by George Biallas]
+** [     Fabrication drawings ]
+** [https://wiki.jlab.org/pcrewiki/images/3/3d/PO_15-P0128_Drawing%2C_Calculation_Review-3.pdf   Review of calculations by George Biallas]
 ** [   Vacuum and pressure test results by vendor and certificates of materials]
 * Run documentation