Difference between revisions of "Data Acquisition System"
Jump to navigation
Jump to search
| Line 48: | Line 48: | ||
5- Change Mott_SemiInt to the new mode: reads integral and pedestal instead of only integral | 5- Change Mott_SemiInt to the new mode: reads integral and pedestal instead of only integral | ||
6- Add Block Readout | 6- Add Block Readout | ||
| − | 7- | + | 7- Upgrade the time-of-flight readout to the FADC TDC mode |
| − | 8- | + | 8- upgrade the scalers readout to the FADC Scaler mode |
9- At one time, we used minicom to hard reboot the Mott DAQ VME crate. This service was discontinued. Instead, we will use the RS232 | 9- At one time, we used minicom to hard reboot the Mott DAQ VME crate. This service was discontinued. Instead, we will use the RS232 | ||
connection on the CAEN VME64X VME8200. | connection on the CAEN VME64X VME8200. | ||
Revision as of 12:38, 25 April 2014
DAQ Hardware
- Electronic Map of Mott Crates (February 12, 2014):
Media:ElectronicsMap_Feb122014.pdf
Media:ElectronicsMap_Feb122014.pptx
- Cabling of FADC, Scalers, and TDC (February 12, 2014):
- DAQ Timing (February 12, 2014):
Media:DAQ_Timing_Feb122014.pdf
Media:DAQ_Timing_Feb122014.pptx
DAQ Software
Manuals and References
- CAEN VME Crate Manual - VME8200 9U 21Slot (VME64x backplane with no P0 connector) media:VME8200_Manual.pdf
- Jefferson Lab Data Acquisition Group CODA Wiki [1]
To-do List
1- Update MottOnline 2- Add BPM Analysis 3- Replace "PEPPo" with "Mott" in scripts, decoder, ... . 4- Add delayed helicity analysis for Mott_Sample and Mott_SemiInt Modes. Delayed analysis is already included for Scalers and PEPPo_Int Modes. 5- Change Mott_SemiInt to the new mode: reads integral and pedestal instead of only integral 6- Add Block Readout 7- Upgrade the time-of-flight readout to the FADC TDC mode 8- upgrade the scalers readout to the FADC Scaler mode 9- At one time, we used minicom to hard reboot the Mott DAQ VME crate. This service was discontinued. Instead, we will use the RS232 connection on the CAEN VME64X VME8200.