Difference between revisions of "Cables"
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
[[File:GoWTJr.png|400px]] | [[File:GoWTJr.png|400px]] | ||
| − | * Board schematics | + | * The HV is distributed from the top of the board through 3 ribbon cables. |
| + | * The LED sitting in front of each PMT are controlled by a ribbon cable connecting at the bottom of the board | ||
| + | * Anode signal from each channel get out of the board through the opposite side and through SMA connectors | ||
| + | * Board schematics (to be added) | ||
| + | |||
| + | == HV ribbon cables == | ||
| + | |||
| + | == LED control cables == | ||
| + | |||
| + | == Anode signal cables == | ||
Revision as of 04:34, 25 August 2020
Voltage divider
- Voltage divider schematics
- The connector on the voltage divider is Samtec Part # IPL1-105-01-L-S-RA-K:
- Pictures of the assembly:
Custom cable from voltage divider to PCB boards
The cable has a SAMTEC connector IPD1-05-S-K on one side. On the other side the cable has a SMA RS PRO 546-3210 connector (Datasheet, Crimp instructions) and Fischer connector S 102 A 018. The cable length is 375 mm.
- Cable schematics
- Picture of the cable:
PCB boards (one per detector column)
The HV and the anode signals of each column of the detector is routed through a PCB board. This boards also holds one LED per channel.
- The HV is distributed from the top of the board through 3 ribbon cables.
- The LED sitting in front of each PMT are controlled by a ribbon cable connecting at the bottom of the board
- Anode signal from each channel get out of the board through the opposite side and through SMA connectors
- Board schematics (to be added)