Revision as of 23:42, 9 November 2015

The review will take place November 12, 2015 at 8:30 am in L102

Agenda

8:30 Executive Session
9:00 Physics goals of the PRad experiment (15 min) - Haiyan Gao
9:15 Overview of the experimental setup, required beam parameters, alignment, HyCal, run plan (30 minutes) - Ashot Gasparian
- Draft Run plan
9:45 Coexistence with CLAS12 project, including discussion of schedule, manpower needs, service provider needs, and infrastructure requirements (30 min) - Eugene Pasyuk
- PRad Installation Schedule
- CLAS12 activities
10:15 Coffee Break
10:30 Target: parameters, safety (20 min) - Chris Keith
- PRad target manual and hazard analysis
- PRad target operation manual
10:50 GEM and DAQ integration (20 min) - Nilanga Liyanage
11:10 DAQ, on-line and off-line software (20 min) - Chao Peng
11:30 Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min) - Bob Miller
12:00 PRad Beam Commissioning and Procedures (20 min) - Arne Freyberger
12:20 Run documentation COO, ESAD, RSAD, etc. (30 min) - Dipangkar/Mahbub

@@ Line 24: / Line 24: @@
 ** [https://wiki.jlab.org/pcrewiki/images/2/25/PRad_Target_Operations.pdf PRad target operation manual]
 * '''10:50'''	GEM and DAQ integration	(20 min)		-		''Nilanga Liyanage''
-* '''11:10'''	DAQ, on-line and off-line software	(20 min)	-		''Chao Peng''
+* '''11:10''' [https://wiki.jlab.org/pcrewiki/images/e/e7/DAQ_and_software.pdf	DAQ, on-line and off-line software]	(20 min)	-		''Chao Peng''
 * '''11:30'''	Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min)		-									''Bob Miller''
 * '''12:00'''	PRad Beam Commissioning and Procedures	(20 min)	-	''Arne Freyberger''