Revision as of 10:58, 6 November 2015

The review will take place November 12, 2015 at 8:30 am in L102

Agenda

8:30 Executive Session
9:00 Physics goals of the PRad experiment (15 min) - Haiyan Gao
9:15 Overview of the experimental setup, required beam parameters, alignment, HyCal, run plan (30 minutes) - Ashot Gasparian
- [ Run plan]
9:45 Coexistence with CLAS12 project, including discussion of schedule, manpower needs, service provider needs, and infrastructure requirements (30 min) - Eugene Pasyuk
- PRad Installation Schedule
- CLAS12 activities
10:15 Coffee Break
10:30 Target: parameters, safety (20 min) - Chris Keith
- PRad target manual and hazard analysis
- PRad target operation manual
10:50 GEM and DAQ integration (20 min) - Nilanga Liyanage
11:10 DAQ, on-line and off-line software (20 min) - Chao Peng
11:30 Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min) - Bob Miller
12:00 PRad Beam Commissioning and Procedures (20 min) - Arne Freyberger
12:20 Run documentation COO, ESAD, RSAD, etc. (30 min) - Dipangkar/Mahbub
12:50 Lunch
13:30 Executive Session
15:30 Closeout

@@ Line 40: / Line 40: @@
 *[https://www.wiki.jlab.org/pcrwiki/ Overview of the experimental setup]
 *[https://www.wiki.jlab.org/pcrwiki/ Coexistence with CLAS12 project]
-*[https://www.wiki.jlab.org/pcrwiki/ Target]
+*[https://wiki.jlab.org/pcrewiki/images/d/d1/PRadTargetReviewSlides.pdf Target]
 *[https://www.wiki.jlab.org/pcrwiki/ GEM and DAQ integration]
 *[https://www.wiki.jlab.org/pcrwiki/ DAQ, on-line and off-line software]