Difference between revisions of "Target Boiling Study"

Revision as of 21:53, 13 December 2017

Note: Boiling Study is mainly carried out on HRS-L at higher rate while the HRS-R will have less rate because of the higher P0 value. At the moment the dipole of the HRS-R is not working, therefore, only the left arm will be used for the boiling study.

Empty-Target-Cell for checking the aluminium contamination from end-cups in the gas

Run number	Target	Beam Current	Raster Size	E_beam [GeV]	P₀ [GeV/c]	θ_e [deg]	Comment
	Empty-Cell	22.5uA	2x2 mm	4.3	2.6	17	Need to have close statistics compared with H3/He3 in the central region after cutting out the end-cups

C12 target for a normalization check for beam-current dependent rate check (Share the data set with BCM calibration date.

@@ Line 1: / Line 1: @@
 [https://wiki.jlab.org/tegwiki/index.php/Installation_and_Commissioning <b>Back to Installation and Commissioning</b>]
-* Note: Boiling Study is mainly carried out on HRS-L at higher rate while the HRS-R will have less rate because of the higher P0 value.
+* Note: Boiling Study is mainly carried out on HRS-L at higher rate while the HRS-R will have less rate because of the higher P0 value. At the moment the dipole of the HRS-R is not working, therefore, only the left arm will be used for the boiling study.
 * <b>H3 Target</b>