Difference between revisions of "Raster Size Calibration"
Jump to navigation
Jump to search
| Line 7: | Line 7: | ||
<li> Run spotL/spotR | <li> Run spotL/spotR | ||
<li> Look at <b>BPM</b> plots, note actual rastered beam size | <li> Look at <b>BPM</b> plots, note actual rastered beam size | ||
| − | <li> Request 5uA beam with modified raster size, to try to get actual raster size to 2x2mm | + | <li> Request 5uA beam with modified raster size, to try to get actual raster size closer to 2x2mm |
<li> Iterate 2-5 until the actual raster size is 2x2mm | <li> Iterate 2-5 until the actual raster size is 2x2mm | ||
<li> Note requested "MCC Raster Size" on the whiteboard | <li> Note requested "MCC Raster Size" on the whiteboard | ||
<li> Make a HALOG entry! | <li> Make a HALOG entry! | ||
</ol> | </ol> | ||
Revision as of 14:17, 5 October 2017
Back to Installation and Commissioning
Raster Size Tuning
- Move target to Carbon Single-Foil
- Request 5uA beam with 2x2 raster
- Run spotL/spotR
- Look at BPM plots, note actual rastered beam size
- Request 5uA beam with modified raster size, to try to get actual raster size closer to 2x2mm
- Iterate 2-5 until the actual raster size is 2x2mm
- Note requested "MCC Raster Size" on the whiteboard
- Make a HALOG entry!