Difference between revisions of "Run Group C"

From clas12-run
Jump to navigation Jump to search
Line 109: Line 109:
 
** '''Changing raster offset''': ask MCC to NOT correct whatever happens on 2H01. Note new 2H01 values and inform MCC of the new 2H01 x and y values - then they can keep the beam at those positions.
 
** '''Changing raster offset''': ask MCC to NOT correct whatever happens on 2H01. Note new 2H01 values and inform MCC of the new 2H01 x and y values - then they can keep the beam at those positions.
 
* Experiment setup is "FTout/ELMO"
 
* Experiment setup is "FTout/ELMO"
 +
* Oct 26, 2022: Solenoid setpoint is now -2418.5
  
 
PLAN:
 
PLAN:
Line 122: Line 123:
  
 
=== GENERAL INFORMATION ===
 
=== GENERAL INFORMATION ===
 +
 +
* Controlled access: after you call MCC, they will only drop the hall to controlled access once you go down and call them and take a key. Then call when they should go back to beam permit and call again to say you want the beam back and what beam current. Rapid access is controlled access without RadCon.
  
 
* '''mon12''': It can happen that histograms do not get cleared completely at run start. This is seen eg as an excess of small multiplicities. The remedy is to quit mon12 and open it again.
 
* '''mon12''': It can happen that histograms do not get cleared completely at run start. This is seen eg as an excess of small multiplicities. The remedy is to quit mon12 and open it again.

Revision as of 12:41, 26 October 2022

[edit]


Clas12design.png