Difference between revisions of "The HPS Run Wiki"

From hps run
Jump to navigation Jump to search
Line 126: Line 126:
 
| valign=top width=50% |
 
| valign=top width=50% |
  
== Run Plan September 29 - October 1, 2021 ==
+
== Run Plan October 1 - 5, 2021 ==
 +
 
 +
<!-- * Restor physics quality beam for the production running (see procedures on the right) -->
 +
* '''Take production data taking''':  120 nA beam on the 20 um W target, PROD77 configuration, production trigger '''hps2021_v2_3.trg'''. Each run should last about 4 hours.
 +
* At 8 am on Tuesday, October 5, Stop data taking, turn OFF detectors, retract SVT and get ready for 2H02 harp scans to study the effect of the prebuncher setting on the beam profile (see test plan https://opsweb.acc.jlab.org/CSUEApps/atlis/task/23350)
 +
* Beam will be down and the hall will go to restricted access around 9:30 am on Tuesday, October 5, for the tour and the hall work (see below)
 +
* If an opportunity arises (long machine down), request controlled access to refill the SVT chiller and reset the chiller camera. When restoring the beam, see if the prebuncher test can be performed then (contact to RC).
  
* Restor physics quality beam for the production running (see procedures on the right)
 
* '''Take production data''':  120 nA beam on the 20 um W target, PROD77 configuration, production trigger '''hps2021_v2_3.trg'''. Each run should last about 4 hours.
 
  
 
<!-- * Special runs: ''' At around noon we should start following special runs''', then continue with a production.
 
<!-- * Special runs: ''' At around noon we should start following special runs''', then continue with a production.
Line 138: Line 142:
 
<!-- ** Random Trigger run, ~ 2 hour run at full luminosity ( 120 nA), with Faraday Cup and Pulser trigger only, changed to give 24 kHz trigger rate. -->
 
<!-- ** Random Trigger run, ~ 2 hour run at full luminosity ( 120 nA), with Faraday Cup and Pulser trigger only, changed to give 24 kHz trigger rate. -->
  
===Hall Access Items:===
+
===Hall Access Items (Tuesday, October 5):===
* Install new stand for FCup camera: // Denny
+
* Refill SVT chiller (PF/Matt)
 +
* Reboot SVT chiller camera (PF/Matt)
 
* turn on the compressor for RICH: // Valery and Bob
 
* turn on the compressor for RICH: // Valery and Bob
  

Revision as of 15:26, 1 October 2021


[edit]


Svtpic.png

Ecalpic.png