Revision as of 11:12, 11 November 2015

The review will take place November 12, 2015 at 8:30 am in L102

Agenda

8:30 Executive Session
9:00 Physics goals of the PRad experiment (15 min) - Haiyan Gao
9:15 Overview of the experimental setup, required beam parameters, alignment, HyCal, run plan (30 minutes) - Ashot Gasparian
- Draft Run plan
9:45 Coexistence with CLAS12 project, including discussion of schedule, manpower needs, service provider needs, and infrastructure requirements (30 min) - Eugene Pasyuk
- PRad Installation Schedule
- CLAS12 activities
10:15 Coffee Break
10:30 Target: parameters, safety (20 min) - Chris Keith
- PRad target manual and hazard analysis
- PRad target operation manual
10:50 GEM and DAQ integration (20 min) - Kondo Gnanvo
11:10 DAQ, on-line and off-line software (20 min) - Chao Peng
11:30 Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min) - Bob Miller
12:00 PRad Beam Commissioning and Procedures (20 min) - Mike Spata
12:20 Run documentation COO, ESAD, RSAD, etc. (30 min) - Dipangkar Dutta

@@ Line 49: / Line 49: @@
 *[https://wiki.jlab.org/pcrewiki/images/e/e7/DAQ_and_software.pdf DAQ, on-line and off-line software]
 *[https://wiki.jlab.org/pcrewiki/images/d/db/PRad_ERR_Design_and_Engineering.pdf Engineering aspects]
-*[https://www.wiki.jlab.org/pcrwiki/ PRad Beam Commissioning and Procedures]
+*[https://wiki.jlab.org/pcrewiki/images/5/51/ERR_PRad_Beamline.pdf PRad Beam Commissioning and Procedures]
 *[https://wiki.jlab.org/pcrewiki/images/a/a5/Prad_hazana.pdf  Run Documentation]