Revision as of 15:31, 23 March 2016

The review will take place March 25, 2016 at 9:00 in L102

9:00 Executive Session /10 min/
9:10 Equipment and installation status, run plan, the expected results. (1.1, 2.1, 2.1, 4.1, 5.1, 7.2)– Ashot Gasparyan /30+15 min/
9:55 GEM and its DAQ system (7.1, 7.2) – Kondo Gnanvo /20+10 min/
10:25 Manpower, data analysis procedure (3, 7.3) – Haiyan Gao /20+10 min/
10:55 Run documentation (8) – Eugene Pasyuk /10+5 min/
11:10 Coffee Break /15 min/
11:25 Discussion /20 min/
11:45 Executive Session /30 min/
12:15 Closeout

[*] - items of the previous committee report covered in the presentation

8:30 Executive Session
9:00 Physics goals of the PRad experiment (15 min) - Haiyan Gao
9:15 Overview of the experimental setup, required beam parameters, alignment, HyCal, run plan (30 minutes) - Ashot Gasparian
- Draft Run plan
9:45 Coexistence with CLAS12 project, including discussion of schedule, manpower needs, service provider needs, and infrastructure requirements (30 min) - Eugene Pasyuk
- PRad Installation Schedule
- CLAS12 activities
10:15 Coffee Break
10:30 Target: parameters, safety (20 min) - Chris Keith
- PRad target manual and hazard analysis
- PRad target operation manual
10:50 GEM and DAQ integration (20 min) - Kondo Gnanvo
11:10 DAQ, on-line and off-line software (20 min) - Chao Peng
11:30 Engineering aspects: beam line, vacuum vessel, window, installation, safety (30 min) - Bob Miller
12:00 PRad Beam Commissioning and Procedures (20 min) - Mike Spata
12:20 Run documentation COO, ESAD, RSAD, etc. (30 min) - Dipangkar Dutta

@@ Line 43: / Line 43: @@
 *[https://wiki.jlab.org/pcrewiki/images/0/06/HYCAL_THA.pdf HyCal Task Hazard Analysis Worksheet]
 *[https://wiki.jlab.org/pcrewiki/images/5/5d/HYCAL_manual.pdf HyCal Manual]
-*[HyCal Transporter Procedures]
+*[https://wiki.jlab.org/pcrewiki/images/4/4d/HYCAL_transporter_procedures.pdf HyCal Transporter Procedures]
 ==== PRad GEM ====